The ACH is currently in the process of being phased out and replaced by the Enhanced Combat Helmet (ECH), an improvement upon the ACH derived from its design; however, both the ACH and the newer ECH are being replaced by the Integrated Head Protection System.
History
2000s
The Advanced Combat Helmet was first fielded beginning in 2003[N 1] in limited numbers to eventually replace the PASGT helmet.[6] In 2006, 102,000 helmets were ordered from ArmorSource, of which 99,000 were delivered when the contract was fulfilled and properly closed. In 2007, the Army introduced a ballistic "nape pad" that attaches to the ACH's rear suspension system. Of these, 430,000 were to be issued in the Rapid Fielding Initiative (RFI).[6] Beginning in 2008, the Army's Program Executive Office Soldier outfitted soldiers of the 101st Airborne Division and 4th Infantry Division bound for Iraq with helmet-mounted sensors designed to gather data on head injuries (or traumatic brain injuries) caused during IED detonations. The data collected will help with the design of improvements to the ACH's suspension and chin strap systems.[7] In May 2009, 55,000 of these were in storage and 44,000 were in use by U.S. Army, Navy, and Air Force personnel. The 44,000 helmets in use by service members were recalled by the U.S. Army in May 2010 due to potentially defective materials being used.[8] Eventually, the contractor agreed to pay a $3 million fine, without admitting to any wrongdoing by the contractor.[9]
In May 2009, 34,218 ACHs made by the Gentex Corporation were recalled. Certain screws attaching the chinstrap and other parts to the helmet did not conform to specifications in the contract. The screws failed ballistics tests at extreme temperatures. Gentex alleges its subcontractor had fabricated compliance certificates for the screws.[citation needed] An OCP cover for the Advanced Combat Helmet began fielding in late 2009 for soldiers deployed in Afghanistan.[10]
The shape of the ACH is virtually identical to the MICH TC-2000. Compared to the PASGT helmet, the front brow is eliminated to improve upwards visibility and allow easier mounting of night-vision goggle brackets. The side brim has been raised to the point that the entire lower brim of the helmet is "flat" compared to the PASGT which curves upwards at the back. This is to allow greater compatibility with communications headsets and improve hearing when headsets are not used.
The ACH uses ballistic fiber such as kevlar and twaron.[13] In 2007, the Army developed and introduced a ballistic "nape pad" that attaches to the ACH's rear suspension system and coincided with the introduction of the Improved Outer Tactical Vest (IOTV).
The pad reduces soldier deaths from fragmentation wounds to the neck and lower head.[14][15]
The Lightweight Advanced Combat Helmet Generation II (LW-ACH Gen II) weighs one pound less than the original ACH while offering the same ballistic protection.[16][17]
^C. Todd Lopez (12 August 2010). "New uniform for OEF protects Soldiers, hides them better". Archived from the original on February 4, 2011. Retrieved 31 January 2011. Gear being fielded to Soldiers with the new pattern includes a cover for the Advanced Combat Helmet, the Extended Cold Weather Clothing System, the Fire Resistant Army Combat Uniform, the Improved Outer Tactical Vest, both the sun hat and patrol cap, name and service tapes for the FR ACU, and multiple pieces of modular lightweight load-carrying equipment (MOLLE).
^"Archived copy". isayeret.com. Archived from the original on 13 September 2016. Retrieved 14 January 2022.{{cite web}}: CS1 maint: archived copy as title (link)