B4-mount  The B4 lens mount was standardized in 1992 by the Broadcasting Technology Association (BTA) and is defined in BTA S-1005.[1] This standard defines the physical mount, but also optical properties and some electrical connections. The B4 mount defines the sensor to have a diagonal size of 11 mm (a so-called 2/3" size sensor). The B4-mount is used by practically all 2/3" broadcast lenses and cameras (as of 2019). Although the standard was set in 1992, the B4 mount already existed before 1980. The Sony BVP-300, produced from 1978, was possibly the first camera with a B4 mount. Further, all Sony Betacam cameras had a B4 mount.[2] The BTA was formed by Japanese broadcaster NHK and included members from Canon, Fuji, Hitachi, Ikegami, JVC, Matsushita (Panasonic), Nikon, Sony and Toshiba. It was formed in the mid-1980s and set various standards for television. It is now part of ARIB, Association of Radio Industries and Businesses.[3][4] MechanicalThe flange of the mount defines the positioning of the lens relative to the image sensor. A ring is present around the opening on the camera which, when rotated, tightly locks the flange of the lens against the camera. A pin on the top side of the lens flange and a hole in the camera mount make sure the lens cannot be mounted at an angle.[5] OpticalThe B4-mount has its image projected at 48 mm behind the lens mount flange (in air). The standard defines that a prism splits the light to form separate images planes for the colours red, green and blue. A correction for chromatic aberration is also part of the standard: the red sensor should be 10 μm further, and the blue one 5 μm further than 48 mm. This fitted well with established TV-camera technology using 3 tubes, and also with 3CCD, a technology in development at the time of the definition of the standard.[6] The standard defines that the diagonal size of the projected image should be 11 mm, but does not define a resolution to be used. In the past standard definition was captured at 4:3 aspect ratio. Nowadays, cameras with the same mount capture HD with 16:9 aspect ratio, or even 4K video, thanks to improved lenses.[7] ElectricalThe lens mount is accompanied by a connector for the electrical connections. It powers the lens motors, controls the iris and allows a few buttons on the lens handle to control camera functions. The connectors are made by Hirose. On the camera is a HR10-10R-12S receptacle, and on the lens a cable with a HR10-10P-12P plug.[8]
References
|
